So got out in the garage day to tackle it and replace the old poor quality repro light housings for new top quality ones and figure out the wiring issue….so shiny!
Success…ish
Findings
- only one of the lamp holders had a visible earth bolted onto the back of the screw holding the lamp...
It’s been converted by the look of it as it runs two bulbs in each light rather than the single bulb US Spec.
Top - indicator light
Bottom - side light/brake light
As part of identifying the working gremlin I’m swapping out the old lamp holders the the better spec with direct connections in...
67 Panel.
- Il get out in the garage tomorrow to check the spade terminal (could of been missed as not visible when I took the cluster out as it appears it has a snug rubber boot on the wires)
- Bulb is fine as it illuminates when I put my side lights on
Sparkywig
- the additional ground...
Hi All
So today I tinkered with the buss replacing the rear light seals and putting on the original red lenses.
Long and short in the process of doing so I’ve managed to wipe out my hazards and rear right (as you look at it) break light.
Findings along the way:
- the left hand light cluster...