Recent content by bambam

i had to press my new wings as they were to short the bend section was incorrect did it with a hydraulis 5 ton press then they fitted .i just cut the lot out with a grinder fitted to a cutting disc...

Please send photos of wife I may have a bike to trade

O M G I thought my bay was bad when i bought it but I was wrong ... Your flinstone bus is way worse ... I wouldn't spend anymore time on it buy another ....... Oh yes I am looking for a new bus do you want to sell it :lol: :lol:

sounds about right ...... try dropping the voltage by putting all the lights on :idea:

This is my current engine

Re cooling I have no idea...I will prob make a radiator I dont know where I will fit it yet i may try and fit it below the battery or some where I have no idea :lol: I think that might be a minor problem compared to the wiring,gearbox,brakes,fitting etc or am i over reacting

Ok got the car and even told the wife ........................

hay great web site link i will give them a call when i get a mo . the site should make the conversion easier as for stopping the thing ha ha I laugh at danger :lol: :lol: :lol:

If i am correct the subaru 3.3l is around 250 bhp that should liven the old beast up a bit i am going to see the motor thurs to get the engine measurements etc

Thank you for putting me right

i will look on a t3 web site and see if any of the square drivers have posted any pictures

there are only two things the distributer needs one is a feed back from the coil the other goes to a suppressor if the wire connects to the points it goes to the coil it sounds about the correct lengh

i fitted gen rubbers all round good quality but very tight to fit took four men to fit windscreen and two hours plus the side rubbers were not to bad but still tight :lol: :lol: it wont be cheap if you pay for them to be done

here we go just been offered a 3.3 litre subaru complete car running with 4th gear problem my question is will it fit its the 6 cylider non turbo :lol: :lol: any ideas on gearbox

just purchased air shocks for a chevy corvette from america with pipe work etc will put picks on when they are fitted :D :D