Ben72Bay's latest activity
Help Support Early Bay Forum:
-
Ben72Bay reacted to ozziedog's post in the thread Help needed, Losing Power when over 50 mph. with
Like.
I’m sticking with the freebie checks so far. Did you say you’ve changed your condenser? My next freebie is to open up your 009 and have... -
Ben72Bay reacted to Sausage's post in the thread Help needed, Losing Power when over 50 mph. with Like.
I fitted the new fuel pump, push rod and gaskets and tested the pressure again and it was definitely higher, around twice as far as...
-
Ben72Bay reacted to ozziedog's post in the thread Help needed, Losing Power when over 50 mph. with Like.
As Mattie says above, these new pedestals have got some extremely nasty and anti social bad habits, like pinching your pumps pushrod...
-
Ben72Bay reacted to matty74's post in the thread Help needed, Losing Power when over 50 mph. with Like.
Go easy with the Bakelite pedestal, as they can break easy. If the rod is freely moving up and down and the correct length I’d be...
-
Ben72Bay reacted to Sausage's post in the thread Help needed, Losing Power when over 50 mph. with Like.
I took the fuel line off to the pump and it’s coming out nice and fast so am going to get a new pump, Bakelite bit and pushrod tomorrow...
-
Ben72Bay reacted to ozziedog's post in the thread Help needed, Losing Power when over 50 mph. with Like.
No it don’t sound brill, it should be gushing to the bottom of the bottle well at least well past half way. So it sounds like it might...
-
Ben72Bay reacted to ozziedog's post in the thread Help needed, Losing Power when over 50 mph. with Like.
Hi Pete. Let’s have a go at the freebies first. Fuel pressure check. Empty one and a half or two litre clear drinks bottle. Disable the...
-
Sometimes you can take the remnants of the snapped cable, begin to unwind the end so that it still fits down the tube, then attach the...
-
Well I did it but it was a little unconventional. It was sticking very early on down the tube so I got past this by pinching the cable...
-
I had this with my throttle cable about 15ys ago, I found the area of the block and sliced it with a grinder slitting disc, opened it up...