Recent content by J4yman

Apologies, Life got in the way. I have been doing a few bits including Electronic Ignition, Fuel Lines, rear seat belt points added, purchased a new whole front from Busfest. Just need a competent VW Welder to get that on. But it's a big job as everything needs to keep it's alignment. Fixed the...

No worries, I know some Steering boxes are marked with a white pen mark for alignment when re installing. I was thinking I was missing something with Penrite. Happy New Year

I got some stuff from the guy in Northampton who refurbs them N2 Engineering. Guessing it might be the stuff if it's the go to gear.

What's a penrite. I have this to do early next year. I have the gasket and fluid ready.

I still have it on the to do list but the wheel maybe off soon as I need a new front support panel and want to tidy up the dashboard(spray and clean) whilst it's off. So will make sure it's fixed up when it goes on. Thanks

I did a little experiment on this subject. Before and after pictures then the video of my findings. The video is too big but the long and short of it was that £1 shop super glue was the best stuff. The other thing tested were Stormsure adhesive, double sided sticky tape which is a great quick...

When they are sitting there on site and you can use them🤙

This was my solution, mine were soo tight. These Sash clamps sorted it. Slowly slowly

Fair condition slight but of stitching required(see photo) But remember it's a 50 year old original tent. In its original storage bags. Collection only ( Coventry)

I think I will do this too when I am changing the oil. Are their specific seals for them?

So the. Here's the oil pressure, 950 lower reading, 2500 rpm second reading and 3000 3pm third reading. Probably not the best oil pressure guage. What I did notice was that the temp on the dipstick was less than the oil pressure guage input. See pics

I have a post in technical called Hot Engine and Oil light on advice needed Could I have your view on it to help me get another year or so.

Sorry for the long post. I have a stock engine with Electronic Ignition and a new fuel pump after a recent failure. New oil and I have checked the oil pressue with a guage. The guage was showing 19lb on idle after driving to the guy who tested it for me which was only 2.5 miles away so the...

I wonder if I could pick your brains on a Oil light issue.

Seems strange, I would perhaps look at the plate adjustment in the cab to see if you can stop it doing this. Along with making sure the bushes on the road underneath are good.