I used some marine bench foam. I think it was 1inch. Originally I tried 2” and it was too thick. The pillow section I left thicker as it’s more comfortable. (Also didn’t want to unpick it). It still makes closing a little harder and could have been mm thinner but I’ll cope for now.
I think mine is an original beam that has been narrowed and adjusters fitted. I’ve no experience in. Recognising the spindle type. Lots has been done though and it looks to be high quality. Hubs are custom drilled for Porsche 5 stud.
I’d better start gathering the tools and putting the bay up...
Thanks everyone, looks as though this is going to be painful. Still, no van until it’s done! I rather take it somewhere to get done but know of nowhere local.
I found this which makes it a little more understandable to me.
When he does the top adjuster, he says that it should be done differently. What is he missing in his process?
I removed the extra coil over shocks and swapped for blisten ones from T2D. Rides better but sits 2 or so cm lower. This will not be good for the family camps. I have adjusters but have never used them before. What are the steps to lift it back up 2-3 cm? I’ve watched a few vids on YouTube for...