Recent content by PIE

Early Bay Forum

Help Support Early Bay Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. PIE

    Wanted Alluminium Cooler

    Chest type 560x400x350 needs to be good nick, Cheers
  2. PIE

    Balance/ compensator bar

    In the remote chance anyone with the same problem searches this an early bay compensator fits a split with the handbrake right next to the tool chest >58 I think
  3. PIE

    Balance/ compensator bar

    Has anyone got one to hand so I could get some dimensions, Im missing one from mw 57 split and the early bay one looks like it may fit Cheeres Dave
  4. PIE

    Hard to start when warm, pointers ?

    This is what I do with mine to stop it dumping more fuel in when its already flooded.
  5. PIE

    Hard to start when warm, pointers ?

    Im not sure what you mean there, if they are 34 ict's or copies of I have the below on mine. They are an easy fit and do help, you must keep an eye on the nuts as they tend to work loose then need to be retightened after a bit of use...
  6. PIE

    Hard to start when warm, pointers ?

    Are they a copy of 34 ict's ?
  7. PIE

    Help - Split Charge Fuse Blowing...

    Wouldn't be the same problem as the OP, his fuse is popping between the two batteries, if yours is a large draw from the LB side it would be the fuse out from your LB, the OPs problem is charging side and in my experience this is almost always the starter motor.
  8. PIE

    Help - Split Charge Fuse Blowing...

    Have you picked up the live for your switch on the relay from a place that goes live with the ignition, like the coil? If you have if the main batt is low when the starter kicks in it will pull a massive draw on the leisure battery and blow the fuse. Just pick up the live from the spade on the...
  9. PIE

    Late tank/sender

    Anyone been running with a late bay tank and sender, wondered how the accuracy and bouncing worked out long term, cheers
  10. PIE

    Centre Stage

    Theres a big do in the next village tonight and they have asked if they can use my crew cab as part of the stage! Will try and get some pictures if its light enough for my camera phone.
  11. PIE

    Custom Canvas

    Cheers mate, I will give them a try, they are not far from me.
  12. PIE

    Custom Canvas

    Anyone know where I can get a good quality custom canvas roof made, also which is the best material, canvas or the acrylic stuff. I like the material that the Reimo roofs on T5s and T4s but can't find out what it is. Concept pop tops are booked up till after the summed :roll:
  13. PIE

    walk through bulkhead trim

    Found this lot in a dark corner, no cracks, anyone any idea what the small pieces and the tapered pieces made of the same material as the seat tops are? It is that long ago that I took em off I can't remember :shock:
  14. PIE

    walk through bulkhead trim

    I have a good set in the garage somewhere but they are off a 73 microbus, are they the same? They have the cards in grey and all the trim, no cracks as I recall, will dig em out tomorrow.
  15. PIE

    Lets put some faces with the Bays!

    Me van Me van with me other van (sorry its late) Me and the Mrs (Im on the left) Brats The pack
Top