Search results

Those are the bits, Would you let me know how much you would like for them. Adrian

Hi looking for a very small part. At the top of the door opening there is a folded seam covered by a push on cover trim, at the top of this are small plastic covers held on with a screw on the side, this part is only about an inch high & wide. Can see it at very top and centre of your seat pic...

My imported early bay from California had them fitted, although I have repurposed them as indicators. Switch was on the gearbox, power feed came from coil terminal and large screw together fuse holder mounted on tinware.

I was obviously overthinking this problem, replaced the brake light pressure switches, now lights work every time with even low pedal force. Thank you to those who replied.

My EB cut out yesterday, engine kept running but little power and died as soon as I dipped the clutch pedal, wouldn't restart straight away but after opening the engine lid it started up and got me home, I put it down to the heat, possibly evaporated fuel in the lines causing a lock.

Yes it is, thanks.👍

The Brake pedal on my 71 LHD bay is extremely hard and takes a lot of pressure before the brake lights activate, The brakes seem to operate ok, and pedal drops slightly when engine starts.this van has disks at front and servo. Any help with this or would it be classed as normal, I am sure the...

I fitted the Air Cooled one to my Early Bay as well as their fuel cut off solenoid to stop fuel flow from the tank in case of a fire, and new fuel pipe. This was a few years ago now.

Mine has a rubber thing like a door stop fitted inside the buddy seat cover on the backrest, seems like it was an original fitting. I have added a triangular brace to the side of the sink unit now.

You can't even park on the seafront roads in most of Clacton on Sea or Walton in Essex signs all along the front no RV's, No Campervans, no vehicles adapted for sleeping, no Trade Vans.

Not just you, I can never remember.

How good are you at wiring and soldering this is what I did to use my IPod. http://www.instructables.com/id/Adding-Auxiliary-Input-for-an-mp3-player-to-an-O/

Don't know if you checked this, Gov MOT Web site shows MOT till 14th Feb 2018 and untaxed, but that might be because they are tax exempt.

Same as on mine, screw on left offset from centre so only goes one way, the bulb holder took some wriggling to get it fitted, bulb holder tight fit.

On mine the hammock that goes over the front seats is stored here and it just pushes that clear of the rear hatch hinges and springs, hope this helps.

Yes my rubber mats have an edge that goes in to the groove, cut outs make them easier to fit.

I made one from metal brake pipe with two pieces of rubber vaccumn pipe on the ends.

Try this, https://www.quasarelectronics.co.uk/Item/smart-kit-1093-intermittent-windscreen-wiper-controller.

This was the colour they supplied, it is slightly darker than shows up here.