Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
6” fuch fitment
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="radish" data-source="post: 599712" data-attributes="member: 4171"><p>With a 71 you can redrill your hubs and drums to 5x130pcd and they should fit. Find a machinist with a pillar drill with turntable and they should do it for less than £50</p><p>Hub caps won't fit though but a machinist can trim 20-25mm off the snout of the drive shafts and then the will. </p><p></p><p> Fuchs are ET45 I think same as comics which I run. I use to run 6" teledials which are ET52.3</p><p></p><p>Cheers Darius</p></blockquote><p></p>
[QUOTE="radish, post: 599712, member: 4171"] With a 71 you can redrill your hubs and drums to 5x130pcd and they should fit. Find a machinist with a pillar drill with turntable and they should do it for less than £50 Hub caps won't fit though but a machinist can trim 20-25mm off the snout of the drive shafts and then the will. Fuchs are ET45 I think same as comics which I run. I use to run 6" teledials which are ET52.3 Cheers Darius [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
6” fuch fitment
Top