Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Accelerator Cable Broke (threaded section)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Whistler" data-source="post: 640264" data-attributes="member: 18919"><p>It is brilliant in short. </p><p></p><p>I got the whole kit, the pedal down to the bar through the chassis and the bar through the chassis to the cable. </p><p>I had replaced the pedal down to the bar through the chassis 8/9 years ago when I restored the bus. I don't know where I got it from but it wasn't Butty's parts, unless it has changed a lot since then. In any case, what I received was a lot better than what I had put on before. </p><p></p><p>The bit through the chassis was a bit of a pain because I couldn't just undo anything, I had to cut it out. Grinder did fit on the pedal side but it didn't fit on the cable side so I used a multi took with a metal blade on it. I also had to use a right angle drill as my normal drill was too big for the new plate on what I believe is the top hat section. </p><p></p><p>Over all, if I did it again, I reckon within an hour it would all be done. And it is so much nicer on the pedal now, I had a lot of play, particularly on the rod through the chassis. I am very glad I replaced it all. Top bit of kit.</p></blockquote><p></p>
[QUOTE="Whistler, post: 640264, member: 18919"] It is brilliant in short. I got the whole kit, the pedal down to the bar through the chassis and the bar through the chassis to the cable. I had replaced the pedal down to the bar through the chassis 8/9 years ago when I restored the bus. I don't know where I got it from but it wasn't Butty's parts, unless it has changed a lot since then. In any case, what I received was a lot better than what I had put on before. The bit through the chassis was a bit of a pain because I couldn't just undo anything, I had to cut it out. Grinder did fit on the pedal side but it didn't fit on the cable side so I used a multi took with a metal blade on it. I also had to use a right angle drill as my normal drill was too big for the new plate on what I believe is the top hat section. Over all, if I did it again, I reckon within an hour it would all be done. And it is so much nicer on the pedal now, I had a lot of play, particularly on the rod through the chassis. I am very glad I replaced it all. Top bit of kit. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Accelerator Cable Broke (threaded section)
Top