Bespoke full flow adapters

[pierrox]

A while back, I was researching for a way to avoid using severe NPT connectors to go around the engine support bar. I came across this photo on the CPS website:


I thought it was very neat and asked them where do I get something similar but for a bay window engine. They told me that it was a customer's setup and they had no idea who made it, but indeed it was a cool setup.

Is there a place in the UK that would do this sort of work? I'm happy to use a 90° to get out of the oil pump cover, but after it I'd rather have one piece and not a gang-bang of adapters.

 

[sparkywig]

They're crimped end lines, almost any hydraulic place will make them up for you.
I've gone a different route though, quite literally.

 

[pierrox]

Whoa that's super neat!
You're drilling into the original gallery?
Can I assume there are more photos in your thread?

 

[sparkywig]

Yes, drilled, tapped and plugged.
Not much on this engine so far as it was destined for my squareback, but it's now going into the deluxe build.