Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Carb backfiring “Weber ICT34”
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Gabs" data-source="post: 644224" data-attributes="member: 33684"><p>After some help as I have a backfire/pop coming through my LH carb and runs flat at 2000rpm especially when I hit the inclined roads. I have replaced all plugs, leads with cap rotor arm and just cleaned LH carb as seen some info on an idle jet block. It runs nice on tickover but when you blip throttle it backfires on that LH carb. Don’t seem to have an air leak as sprayed all around inlet and no change in engine note. </p><p>Should I re-check valve clearance on LH bank ?</p><p>I will take the plugs out and check again.</p><p></p><p>Any help appreciated please.</p></blockquote><p></p>
[QUOTE="Gabs, post: 644224, member: 33684"] After some help as I have a backfire/pop coming through my LH carb and runs flat at 2000rpm especially when I hit the inclined roads. I have replaced all plugs, leads with cap rotor arm and just cleaned LH carb as seen some info on an idle jet block. It runs nice on tickover but when you blip throttle it backfires on that LH carb. Don’t seem to have an air leak as sprayed all around inlet and no change in engine note. Should I re-check valve clearance on LH bank ? I will take the plugs out and check again. Any help appreciated please. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Carb backfiring “Weber ICT34”
Top
