Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Earlybay with 6 rib and 2L type4.. can't shift all gears
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Trikky2" data-source="post: 443444" data-attributes="member: 240"><p>If your having trouble selecting first and third then having the gearstick plate set forwards will make it worse.</p><p></p><p>On the photo, assuming you took it vertically, it does look a little bit far back for neutral - but its hard to be sure. </p><p></p><p>Check you have correctly located the grub screw (the square headed one with lock wire) in the dimple of the selector shaft.</p><p></p><p>When you are sure the selector mechanism is correct you could loosen the engine and gearbox mounts and see if you can ease the engine and gearbox a bit further forward (there is a little bit of leeway/adjustment possible).</p><p></p><p>If all else fails don't despair. It's possible to drill a new dimple for the grub screw a bit further up the shaft.</p></blockquote><p></p>
[QUOTE="Trikky2, post: 443444, member: 240"] If your having trouble selecting first and third then having the gearstick plate set forwards will make it worse. On the photo, assuming you took it vertically, it does look a little bit far back for neutral - but its hard to be sure. Check you have correctly located the grub screw (the square headed one with lock wire) in the dimple of the selector shaft. When you are sure the selector mechanism is correct you could loosen the engine and gearbox mounts and see if you can ease the engine and gearbox a bit further forward (there is a little bit of leeway/adjustment possible). If all else fails don't despair. It's possible to drill a new dimple for the grub screw a bit further up the shaft. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Earlybay with 6 rib and 2L type4.. can't shift all gears
Top
