Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Engine question…
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="AGPlant" data-source="post: 631398" data-attributes="member: 18418"><p>Hi. Firstly it’s a bay crossover 1600 stock. I’ve done all the checks I can think of. So am putting it down to either distributer or carb. It’s a fully standard setup. Timing with a strobe is spot on. Not much adjustment on the carb as screws are poo. It’s a Bocar solex 34 pict-3. Rotor arm and cap are both very clean. New plugs gapped right, even replaced the coil. Vacuum connected properly and working. It’s always been juddery just seems worse than usual.</p></blockquote><p></p>
[QUOTE="AGPlant, post: 631398, member: 18418"] Hi. Firstly it’s a bay crossover 1600 stock. I’ve done all the checks I can think of. So am putting it down to either distributer or carb. It’s a fully standard setup. Timing with a strobe is spot on. Not much adjustment on the carb as screws are poo. It’s a Bocar solex 34 pict-3. Rotor arm and cap are both very clean. New plugs gapped right, even replaced the coil. Vacuum connected properly and working. It’s always been juddery just seems worse than usual. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Engine question…
Top