Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Front badge hole location, measurements?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="andrewblackwell" data-source="post: 644736" data-attributes="member: 32647"><p>This is a pretty old thread, but rather than start a new one, i was just wanting to check the accuracy of these Early Bay Nose badge hole position measurements.</p><p></p><p>I now have a white NOS VW badge i want to fit on our bus instead of the present repro stainless item fitted too low, like a late bay, but the PO welded the holes up.</p><p></p><p>Aside from the great photo shared above i have seen mention of the top two holes being 71mm beneath the grilles lower edge.</p><p>2-11/16" pictured is 68.26mm so this 3mm adrift makes me question what is really correct.</p><p></p><p>Can anyone help with the dims taken from their OG badges, even measurement from grilles lower edge to badges top quadrant/peak, or centre point will get me started.</p><p></p><p>Then i need a brave moment to drill through the welded up holes assuming i hit them correctly.</p><p></p><p>Appreciate any pointers or advice beforehand to minimise the chances of messing it up.</p><p></p><p>Andrew</p></blockquote><p></p>
[QUOTE="andrewblackwell, post: 644736, member: 32647"] This is a pretty old thread, but rather than start a new one, i was just wanting to check the accuracy of these Early Bay Nose badge hole position measurements. I now have a white NOS VW badge i want to fit on our bus instead of the present repro stainless item fitted too low, like a late bay, but the PO welded the holes up. Aside from the great photo shared above i have seen mention of the top two holes being 71mm beneath the grilles lower edge. 2-11/16" pictured is 68.26mm so this 3mm adrift makes me question what is really correct. Can anyone help with the dims taken from their OG badges, even measurement from grilles lower edge to badges top quadrant/peak, or centre point will get me started. Then i need a brave moment to drill through the welded up holes assuming i hit them correctly. Appreciate any pointers or advice beforehand to minimise the chances of messing it up. Andrew [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Front badge hole location, measurements?
Top
