Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Gear rod bush how do you fit?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Whistler" data-source="post: 508855" data-attributes="member: 18919"><p>Might be slightly different as I had the front and main rods out of the bus for resto purposes. First I fed the large one through then attached the front rod with the grub screw. Then it was a case of just putting the new one in. Lots of grease and that was it. The old one was a bit of a pain to pull out but needle nose pliers got it out.</p><p></p><p>I presume as yours is probably in situ you will have to take the linkage off of the gearbox so you can slide the whole rod back to clear the pin that the bush goes over.</p></blockquote><p></p>
[QUOTE="Whistler, post: 508855, member: 18919"] Might be slightly different as I had the front and main rods out of the bus for resto purposes. First I fed the large one through then attached the front rod with the grub screw. Then it was a case of just putting the new one in. Lots of grease and that was it. The old one was a bit of a pain to pull out but needle nose pliers got it out. I presume as yours is probably in situ you will have to take the linkage off of the gearbox so you can slide the whole rod back to clear the pin that the bush goes over. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Gear rod bush how do you fit?
Top
