Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Headlining - one or two parts!?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Tony&#039;s 68 Camper" data-source="post: 641982" data-attributes="member: 23674"><p>Hi everyone,</p><p>I’d like some advice on the headlining of my 1968 early bay. </p><p>I‘m currently restoring mine by replacing all the botched areas around my bus ie new inner/outer sills (both sides), rear wings (somebody had replaced with 71 flared arches), rear corners, battery trays, cross members (both), outriggers and jacking points ……. I could go on but todays question is around my headlining. </p><p>When I took the headlining down, it was in two parts, cab and rear. At the rear of the cab roof section has the same ‘spiky‘ rail ( the same as above the doors) that held the cab headlining. The start of the rear section of the headlining has a wooden rail which had the headlining glued/clipped to it. Hope this make sense to someone?</p><p>In seeking a replacement, I’ve been told only a one piece headlining Is available. If this is the case, what is the ‘spiky’ rail for at the rear of the cab section for? Can someone advise me please.</p><p>thanks, Tony</p></blockquote><p></p>
[QUOTE="Tony's 68 Camper, post: 641982, member: 23674"] Hi everyone, I’d like some advice on the headlining of my 1968 early bay. I‘m currently restoring mine by replacing all the botched areas around my bus ie new inner/outer sills (both sides), rear wings (somebody had replaced with 71 flared arches), rear corners, battery trays, cross members (both), outriggers and jacking points ……. I could go on but todays question is around my headlining. When I took the headlining down, it was in two parts, cab and rear. At the rear of the cab roof section has the same ‘spiky‘ rail ( the same as above the doors) that held the cab headlining. The start of the rear section of the headlining has a wooden rail which had the headlining glued/clipped to it. Hope this make sense to someone? In seeking a replacement, I’ve been told only a one piece headlining Is available. If this is the case, what is the ‘spiky’ rail for at the rear of the cab section for? Can someone advise me please. thanks, Tony [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Headlining - one or two parts!?
Top