Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
How do you go about drilling and turning a front beam?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="stagger lee" data-source="post: 150199" data-attributes="member: 4001"><p>if you pass me your email i can send you a document i wrote some time ago explaining all that is needed to know to lower your t2 at the back and up front with cut'n'twist. inlcudes diagrams and all the trigonometric calculations and formulas to work out drop per twist and drop per spline on the rear. will certainly help you get a clear understanding in your head of what is done/going on.</p></blockquote><p></p>
[QUOTE="stagger lee, post: 150199, member: 4001"] if you pass me your email i can send you a document i wrote some time ago explaining all that is needed to know to lower your t2 at the back and up front with cut'n'twist. inlcudes diagrams and all the trigonometric calculations and formulas to work out drop per twist and drop per spline on the rear. will certainly help you get a clear understanding in your head of what is done/going on. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
How do you go about drilling and turning a front beam?
Top