Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
How to adjust the sliding door lever rods???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="fozworth" data-source="post: 579521" data-attributes="member: 20087"><p>I've just finished fitting a ply panel to the back of the cab divider on my non walk through early bay.The only issue I have now is that I can't push the inner sliding door release lever towards enough to release the to open it .I have to pull the lower of the two lever rods that connect the lever mech to the rear lock mech.</p><p>There are barrel nuts at the front end but they don't seem to shorten the rod length when you turn them ?</p></blockquote><p></p>
[QUOTE="fozworth, post: 579521, member: 20087"] I've just finished fitting a ply panel to the back of the cab divider on my non walk through early bay.The only issue I have now is that I can't push the inner sliding door release lever towards enough to release the to open it .I have to pull the lower of the two lever rods that connect the lever mech to the rear lock mech. There are barrel nuts at the front end but they don't seem to shorten the rod length when you turn them ? [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
How to adjust the sliding door lever rods???
Top