Hydraulic clutch

[creationblue]

Hi

Has anyone got any experience of doing this? I know a T25 hydro box bell housing will fit my 090 box and I can get a Willwood slave easily enough, then it's sorting the pedal end and master cylinder which again is straight forward but what about going bigger than 200mm. I think a late beetle flywheel is 228mm.....

Anyone have any input?

My reason for doing this is I'm slipping a stage 1 pressure plate badly and really don't want to have to stamp on a stage 2 anytime soon :lol:

 

[sparkywig]

1976 on 2.0 l Type 4 engine clutch plate is 228mm.

 

[creationblue]

1976 on 2.0 l Type 4 engine clutch plate is 228mm.

Yea found a few, thinking of machining a flywheel to fit my crank to give bigger area

 

[sparkywig]

Might be worth a go.
I did think of a later T25 waterboxer flywheel, but they're 5 dowel so would involve a bit of work.