Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="*Sam*" data-source="post: 536261" data-attributes="member: 17590">Hi guys after some advice please. I'm fitting a late bay Cu box into my early bay, but I think it it has deeper bell housing than an earlybay box. The holes that the mounting studs and bolts pass through are 60mm meaning none of my hardware is long enough. I also noticed that when I push the engine up to the box and engage it in the input shaft the engine sits won't go onto the mounts on chassis. Can anyone confirm for me if they were was a deeper bell housing made ? And also if this gearbox then has a long input shaft. Cheers Sam</blockquote>