Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Ply Lining steps.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="single boy" data-source="post: 609710" data-attributes="member: 14714"><p>Hi All,</p><p>Going to ply line my T2 Bay bus. Don t know wether to do the sides first and butt up the floor to them, or do the floor first and sit the sides on top ( of the flooring )</p><p>Also regarding the floor to start by filling in the lowest part of the floor ,the largest area with 9mm ply, then, on the part by the side opposite the sliding door where it is already 5/6mm higher, fill the bit with3.5mm ply. What have others done please.?</p></blockquote><p></p>
[QUOTE="single boy, post: 609710, member: 14714"] Hi All, Going to ply line my T2 Bay bus. Don t know wether to do the sides first and butt up the floor to them, or do the floor first and sit the sides on top ( of the flooring ) Also regarding the floor to start by filling in the lowest part of the floor ,the largest area with 9mm ply, then, on the part by the side opposite the sliding door where it is already 5/6mm higher, fill the bit with3.5mm ply. What have others done please.? [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Ply Lining steps.
Top