Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
powder coating warped my pulley?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Trikky2" data-source="post: 357418" data-attributes="member: 240"><p>New pulleys dont have timing marks on the inner edge. Provided its a genuine VW one theres a dimple on the outer edge the pulley, the centre of which is TDC. You can always check its spot on with the old pencil down the plug hole method.</p><p></p><p>If your bus is running stock timing then 7.5 degrees BTDC is 11.5mm ahead (to the right) of TDC on a stock pulley.</p></blockquote><p></p>
[QUOTE="Trikky2, post: 357418, member: 240"] New pulleys dont have timing marks on the inner edge. Provided its a genuine VW one theres a dimple on the outer edge the pulley, the centre of which is TDC. You can always check its spot on with the old pencil down the plug hole method. If your bus is running stock timing then 7.5 degrees BTDC is 11.5mm ahead (to the right) of TDC on a stock pulley. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
powder coating warped my pulley?
Top
