Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Gallery
Progress Pics - Dormobile X-Over
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ozziedog" data-source="post: 628091" data-attributes="member: 13810"><p>Hey, I’ve put a straight edge across my bell housing and with the pedal pressed firmly to the floor boards the thrust bearing face is exactly 52mm at the point in the centre where it swivels so making it as squared up as poss. Take the piece of wood off the pedal and pushed the thrust bearring in as far as it would go and it measured 68mm in the same place, indicating that on this bus, from nuffink to full clutching :roll: your thrust bearing moves 16mm or possibly a little less with the press from the pressure plate against it. That don’t seem much so I went down there and double checked my measurements andvthat’s what it is.</p><p>So 16mm at the bearing surface, and about 22mm (7/8) movement on release bearing arm. Probs because the arm is half as long again as the arms moving the thrust bearing :mrgreen: </p><p></p><p>Ozziedog,,,,,,,,,,,made me a bit giddy that did :mrgreen:</p></blockquote><p></p>
[QUOTE="ozziedog, post: 628091, member: 13810"] Hey, I’ve put a straight edge across my bell housing and with the pedal pressed firmly to the floor boards the thrust bearing face is exactly 52mm at the point in the centre where it swivels so making it as squared up as poss. Take the piece of wood off the pedal and pushed the thrust bearring in as far as it would go and it measured 68mm in the same place, indicating that on this bus, from nuffink to full clutching :roll: your thrust bearing moves 16mm or possibly a little less with the press from the pressure plate against it. That don’t seem much so I went down there and double checked my measurements andvthat’s what it is. So 16mm at the bearing surface, and about 22mm (7/8) movement on release bearing arm. Probs because the arm is half as long again as the arms moving the thrust bearing :mrgreen: Ozziedog,,,,,,,,,,,made me a bit giddy that did :mrgreen: [/QUOTE]
Verification
Post reply
EarlyBay Forums
Gallery
Progress Pics - Dormobile X-Over
Top