- Joined
- May 22, 2009
- Messages
- 519
- Reaction score
- 2
Does anyone make a panel for replacing the rear of the cargo floor that kicks up in-between the rear wheel arches?
As my Danbury was converted from a microbus, it has the extra heater outlets at the rear of the cargo area, I pulled them away at the weekend and I see the heater channels have the top half cut-out to allow for a valve to control the heat into the cargo area. I can make this up from sheet steel but as the panel has pressings for strength I can see it being a PITA to make it, any suggestions?
Mags
As my Danbury was converted from a microbus, it has the extra heater outlets at the rear of the cargo area, I pulled them away at the weekend and I see the heater channels have the top half cut-out to allow for a valve to control the heat into the cargo area. I can make this up from sheet steel but as the panel has pressings for strength I can see it being a PITA to make it, any suggestions?
Mags