Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Sliding door early bay
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bluematt1" data-source="post: 645440" data-attributes="member: 33820"><p>Hi all not sure if anyone can shed some light on my door issue?</p><p>This door has always needed a firm close whilst pushing up near back runner and would close ok from inside, on the odd occasion it may pop on the first catch when driving </p><p>Today I found my door seal split and have since replaced it where by its fits well, during fitment I released the lower and upper runners so not to cut the seal.</p><p>I can still close the door from the outside ok being firm and push door at rear but from inside the mechanism doesn’t seem to have enough pull, I’ve tried adjusting the rods but all this does is roll round the rear catch then not allowing the door to close </p><p>Do these catch / handle mechanisms wear out or is there a work around open to ideas</p></blockquote><p></p>
[QUOTE="bluematt1, post: 645440, member: 33820"] Hi all not sure if anyone can shed some light on my door issue? This door has always needed a firm close whilst pushing up near back runner and would close ok from inside, on the odd occasion it may pop on the first catch when driving Today I found my door seal split and have since replaced it where by its fits well, during fitment I released the lower and upper runners so not to cut the seal. I can still close the door from the outside ok being firm and push door at rear but from inside the mechanism doesn’t seem to have enough pull, I’ve tried adjusting the rods but all this does is roll round the rear catch then not allowing the door to close Do these catch / handle mechanisms wear out or is there a work around open to ideas [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Sliding door early bay
Top
