Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Gallery
Splify 67 built uk panel resto
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="67panel" data-source="post: 611764" data-attributes="member: 13328"><p>Fitted arch, bought a deep throat swager so I can noddle edge and have used panel adhesive so no distortion. found I can weld OK without hurting wrist so did patch repair to lower 1/4 where it had gone through on n/s battery tray. Wheel arch rear end and some welds that were hardtop get to before to do O/S rear. Thinking about swopping spare wheel tray to o/s , need to measure but looks feasible as spare will have to go that side in cupboard . Also started to see if Empi brake kit will fit drop spindles, need to cut lugs off and drill 4 holes in correctly to mount calliper bracket and get a spacer made about 12mm to position it centre to disc. Job for local machine shop me thinks after crimble.</p></blockquote><p></p>
[QUOTE="67panel, post: 611764, member: 13328"] Fitted arch, bought a deep throat swager so I can noddle edge and have used panel adhesive so no distortion. found I can weld OK without hurting wrist so did patch repair to lower 1/4 where it had gone through on n/s battery tray. Wheel arch rear end and some welds that were hardtop get to before to do O/S rear. Thinking about swopping spare wheel tray to o/s , need to measure but looks feasible as spare will have to go that side in cupboard . Also started to see if Empi brake kit will fit drop spindles, need to cut lugs off and drill 4 holes in correctly to mount calliper bracket and get a spacer made about 12mm to position it centre to disc. Job for local machine shop me thinks after crimble. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Gallery
Splify 67 built uk panel resto
Top