Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
step cut heads vs compression
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Chico" data-source="post: 600983" data-attributes="member: 22472"><p>Hi All </p><p></p><p>Im dropping the motor out at the weekend to do some work (leaky push rods flywheel seal etc ) , and was going to swap the heads over </p><p>for some new ones I have .</p><p></p><p>Currently im running a 1776 , with. compression set at 7.6 , I think( from memory deck height was 0.07" using barrel shims ), but looking at the new heads im not sure I allowed for the step cut, when I built it , </p><p>I presume I should ? </p><p></p><p>New ones have a 1.57 mm step , When I set up before I measured gap from piston to top of cylinder , but didn't think about step , should I ? </p><p></p><p>thanks </p><p></p><p>Chico</p></blockquote><p></p>
[QUOTE="Chico, post: 600983, member: 22472"] Hi All Im dropping the motor out at the weekend to do some work (leaky push rods flywheel seal etc ) , and was going to swap the heads over for some new ones I have . Currently im running a 1776 , with. compression set at 7.6 , I think( from memory deck height was 0.07" using barrel shims ), but looking at the new heads im not sure I allowed for the step cut, when I built it , I presume I should ? New ones have a 1.57 mm step , When I set up before I measured gap from piston to top of cylinder , but didn't think about step , should I ? thanks Chico [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
step cut heads vs compression
Top