Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Stepped cam set up
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="thejinx" data-source="post: 592003" data-attributes="member: 15775"><p>I don't think my choke is set right. So far I have done the following</p><p></p><p>Taken off air filter </p><p></p><p>Checked butterfly was closed</p><p></p><p>Stepped cam check meant to have idle screw on the last tooth. Mine is not touching</p><p></p><p>Undid 3 screws on choke rotated chock clockwise until fully open</p><p></p><p>Returned anti clockwise until just closed</p><p></p><p>Tightened screws</p><p></p><p>But if idle screw is not touching the stepped cam then all that was for nothing. </p><p></p><p>Any photos or ideas please</p></blockquote><p></p>
[QUOTE="thejinx, post: 592003, member: 15775"] I don't think my choke is set right. So far I have done the following Taken off air filter Checked butterfly was closed Stepped cam check meant to have idle screw on the last tooth. Mine is not touching Undid 3 screws on choke rotated chock clockwise until fully open Returned anti clockwise until just closed Tightened screws But if idle screw is not touching the stepped cam then all that was for nothing. Any photos or ideas please [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Stepped cam set up
Top