Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Upper Balljoint Boot Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Raggles" data-source="post: 596275" data-attributes="member: 20996"><p>I noticed whilst doing the front brakes on the van that one of the upper ball joint boots has come out from its bottom clip and slid up the shaft. The rubber is still in good condition with no tears and the retaining ring clip is still there. The joint seems good with no apparent wear or problems. Is there any simple way of sorting this and putting in more grease without mucking up the wheel alignment. All the joints were replaced a couple of years back.</p></blockquote><p></p>
[QUOTE="Raggles, post: 596275, member: 20996"] I noticed whilst doing the front brakes on the van that one of the upper ball joint boots has come out from its bottom clip and slid up the shaft. The rubber is still in good condition with no tears and the retaining ring clip is still there. The joint seems good with no apparent wear or problems. Is there any simple way of sorting this and putting in more grease without mucking up the wheel alignment. All the joints were replaced a couple of years back. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Upper Balljoint Boot Question
Top