Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
General Earlybay Chat
Winter work thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="pgtips" data-source="post: 647801" data-attributes="member: 13573"><p>I broke down at the end of summer so engine out over winter to figure out what went wrong. The engine still starts but no drive (auto).</p><p></p><p>Hoping its just flex plate nuts but expecting worse like sheared spline becuase I didn't hear anything flying about, I just instantly lost all drive. I tested later and same, no drive, in all gears.</p><p></p><p>Enforced delay to starting this job, I got manoeuvred into the kitchen by the Mrs(had to fit a kitchen) or I think my Mrs would've sheared mine off as well !</p><p>Kitchen almost done, aim to get it done this week then I can get cracking.</p><p></p><p>I got the bus into the garage up gravel drive using a extension bar on the rear hub nuts so now on a flat surface. Clear up enough room for the engine out and go from there. A new torque converter seal while its out.</p></blockquote><p></p>
[QUOTE="pgtips, post: 647801, member: 13573"] I broke down at the end of summer so engine out over winter to figure out what went wrong. The engine still starts but no drive (auto). Hoping its just flex plate nuts but expecting worse like sheared spline becuase I didn't hear anything flying about, I just instantly lost all drive. I tested later and same, no drive, in all gears. Enforced delay to starting this job, I got manoeuvred into the kitchen by the Mrs(had to fit a kitchen) or I think my Mrs would've sheared mine off as well ! Kitchen almost done, aim to get it done this week then I can get cracking. I got the bus into the garage up gravel drive using a extension bar on the rear hub nuts so now on a flat surface. Clear up enough room for the engine out and go from there. A new torque converter seal while its out. [/QUOTE]
Verification
Post reply
EarlyBay Forums
General Earlybay Chat
Winter work thread
Top
