67panel's latest activity
Help Support Early Bay Forum:
-
667panel replied to the thread Splify 67 built uk panel resto.New battery fitted, yup the old one was toast. Cleaned all the camping gear out and the tool kit, will be some get you home spares left...
-
667panel replied to the thread Double Relay for Electric Fuel Pump and Alternator Warning Light.Well to me that wont work! Maybe with a diode?
-
667panel replied to the thread Double Relay for Electric Fuel Pump and Alternator Warning Light.Pin 85 goes to ground so no you dont have power to both sides
-
667panel replied to the thread Jump Leads.Battery charger with jump start in my local Lidl £40
-
667panel replied to the thread vw toolkit.Oil ,brake fluid, fanbelt ,spark plugs, points and condenser even if you have electronic as easy to swop back, spanners, sockets and...
-
6Just bought a seriously decent set of jump leads from Lidl for twelve quid. The reason these would be absolutely fabulous for an Early...
-
6Cut and turned 68 front beam, bit crusty at the bottom around lower tube. Collection only before it goes in the scrap pile if it is any...
-
667panel replied to the thread Can I bench test my carb to make sure it is working ?.Fuel cut off only closes the idle jet, accelerator pump (what you are talking about) works all the time. Check the ball valve and...
-
667panel replied to the thread Parts For Sale more engine bits clear out a.28/36 twin choke manifold ,I think its brand new. Twin port oil coolers, an alternator that has an external regulator. Fuel pump...
-
667panel replied to the thread Winter repairs.I Waxoiled my bus in all the cavities as well as underside but I do have an applicator with a long wand.
-
667panel replied to the thread Parts For Sale more engine bits clear out a.Carbs, cam and distributor sold.
-
6I’m amazed these are still being advertised. They’ve been knocking about since before they phased out leaded fuel and have been...
-
667panel replied to the thread Can anyone help…wiper spindles..If I remember right its the depth adjust nut then the body grommet then a stainless? washer and finally the top nut. If not I am sure...
