67panel

You should have been able to T of the balance pipe but that should be fitted between manifolds , where does your balance pipe go? Mine...

Fan heater blowing up the left trouser leg will fix that!! To cold to go down my unit and work on the Austin, also waiting for this cold...

Had to make my own fittings when I added a servo, just used brass screw in fuel barbs with 8mm pipe to a home made 8mm T piece and that...

I have repaired a few, normally where the end with the bolt on gets twisted when undoing the nut. Short bit of steel welded over to join...

Well it can do just for a second or so, we used to test starter amp draw with a clip around the lead ammeter and that was a typical read...

Just make sure you use decent thick jump leads and not the cheap thin "glow in the dark" ones. Remember the starter will draw 300 plus...

I have an outer from a later model, not sure what year but no inner . If I have the inner I have not come across it lately.

I bolted a bus bell housing to mine, means you can run the engine before fitting it.

Would be easier to get a magnet on a stick as you have to remove a load to get the heater duct out.

That was my first thought, bit of square with a female end welded to it.

So do I

Rocking it will free a stuck pinion on the ring gear and it will also stop the gears on starter "dog ending" as they call it when the...

More likely a faulty ign switch, had that happen twice as the pattern ones are rubbish and they end up not springing back from start...

Exhaust assembly paste.

Takes 2 lots of hands TBH, stretch the rubber as far as possible and slide the channel over. still might need a tap with a soft hammer...