Recent content by Adam1970bay

Sunday23rd Stafford show ground where dubfreeze use to be, There is a event joint with a 4x4 show http://veedubshow.co.uk/

Roof rack has gone, trailer still for sale. Can take to pre79 event penkridge Sunday 14th Reduced to £260

This is still for sale. Can take to Stanford hall

Cheers I will try the fatter gaskets If not bolt on set up, I am just concern on oil dripping on to hot pipes

I know never going to stop it, I am getting it leaking out of rocker covers. Tried new gaskets, both Silcon and cork, new rocker covers and new clamps none seems to make a difference, it’s dripping straight on to my hot j tubes And recommendations

We have a solar panel to leisure battery which works well but only 12v in the van We have recently brought a jackory and solar panel as my with does a lot of craft fairs and needed to have a 240 supply for an engraver, it’s lightweight

I do I changed from The empi to vintage speed one, a lot easier to get gears. Plus can put in 1st while hand brake is on unlike with the empi

Thanks Basically if I can find some before engine goes back together get them and fit them, guessing there is s a size difference between twin and single port ones.

Hi our bay has both. The trekker has neither, the dog house has the air block offs as does not use the heat exchanger. Both engines are 1641 twin port What are the pros and cons to having no vents flaps and no thermostat? Or would you source getting them and fitting them?

When I did mine. Got some of cables off ebay and others from a garage friend. We printed a poster with the wiring diagram on. On a4 printer so we could work out what we needed, (As what we had already was useless, 3 core house wiring to break lights) I put a few extra wires from front to...

This is still for sale

We have a late bay sliding door that requires a new inner and outer bottom repair Window surround is good There is a few little dents Collection from near Rugeley staffordshire. £100

My replacement engine case. Has no number still got the old knackered one, it was not engraved on it, was just a nail and glue

I currently have a 009 dizzy, I use to have a electric version with vac. That just died as many have said it would. I have a Webber 32/36 progressive carb. Runs ok, bar when warm and slow moving it goes loud and sound like it’s racing, I believe it could be air leek( there is a bolt in the air...

If there are any plans or sizes that would be great if I could have a copy