Recent content by Douglas

Hi are these backing plates still for sale and would you be interested in a trade for some nos ones for an early split.

Hi Can you let me know cost for heater thermostat fo 1600cc.

Hi Paul I sent you a Pm yesterday but not sure if you received it. Can you Pm me please with your number. No problem taking wheels to Stanford Hall

Hi Paul Dazza has now purchased filter but wheels are yours. I am going to Stanford Hall and will take wheels but if you are near Chelmsford Essex might be best to collect.

Pictures of wheels added. They are all the same with two good van tyres on the front two. Currently on my split but came off early bay.

Air filter in excellent condition from 1970 early bay £30. Also an original set of 14" standard wheels £40. All straight but with odd tyres and will need painting.

From the restraining clips lying oin the bell housing it looks like the wrong thrust bearing may have been used. You can use the later clutch plate with the older thrust bearing by using an adaptor which fixes onto the clutch. It is very easy to fit as it just winds onto the sprung teeth and...

I have a dynamo and backing plate just removed from my 1969 single port and all in good working condition. Also regulator and other engine parts. I am in Hatfield Peverel just south of Colchester so not too far away.

Yes still got air filter and other single port engine parts if you need any.

£30.00 seems to be the going rate if that's OK. I am in Essex but will probably be going to Stanford Hall

Hi Steve Interested in your deep sump. Does it come with all fixings as I understand these are not the same as standard on a Berg Sump.

I have just removed one of these from my 69 model if you are still looking. It is the type which has the choke cable from the carb which should be correct for your year. All in perfect condition.

I have just removed my bay engine and intend to put my split 2000cc into it for this summer whilst the split is being restored. The engine has the support points for the bay engine support but it would appear that this fouls the oil take off pipe from the pump cover plate. Is there a different...

Nice wheels. Interested but have you tried fitting them on your bus. My bus is slightly lowered so will need to make sure they fill fit in the wheel arches OK. Offset would be helpful.

You could also try [email protected] as they had some rear cuts at Sandown Park