KevinR

Ok, firstly I would highly recommend Mark at Auto Techniks in Banstead, Surrey - When I arrived he spent time with me going through the...

I am reliably informed I can use either 1mm or 2mm aluminium sheet with vinyl wrapped directly onto it so it should be circa 3mm thick...

I am going to do as you say and if there is enough clearance without the door card I am going to make one out out of aluminium sheet...

Gary, you had the opposite problem to what I have (and still do) I changed to an adjustable beam to lower her front modestly and then...

I have fitted a slimmer door card than it came with but it still has scrim foam in it, think I am just going to try a plain card see if...

I know I am becoming a sliding door 'bore' sorry! It is my wife's bus and I have been tasked with getting the door to open properly !

Thank you very much so looks like there is an 'A" and a 'B' version with the former fitting all years. Odd thing is the 'A'version looks...

I want to buy just two u hinges not the whole bracket to fit to my original centre slider bracket, Schofields (the only ones you can...

Hello Clem, Your suggestion sounds like a great idea! Funnily enough when I originally posted this thread I wondered whether the...

Ah, ok thank you, guess I have a spare buffer then!

Could anyone explain where this goes ? Heritage buffer I have been servicing my sliding door and replaced all the buffers and saw this...

Sorry for the delay, I have removed the door and have cleaned and lubricated the centre hinge , replaced the nylon runner block and the...

I will get her out and take some photos tomorrow and put them up. One thing that interest me is should the slider run parallel with the...

The U hinge seems to rotate to 90° from the body and there does not appear to be much play in the door or hinge?

The sliding door on our RHD 1971 bay rubs on the rear wheel arch. I thought it was due to the door card having too much scrim foam in...