Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Accelerator Cable Snapped - Best way to replace?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Happystamps" data-source="post: 593095" data-attributes="member: 14679"><p>It shouldn't really be necessary. Pull the old cable out from the front and from the back if necessary, and try to push the new one in from the front. If it gets stuck at that bowden section, pull the guide tube out of the fan housing, and look over the gearbox for the flexi. You can pull that out of the steel conduit, where you'll find the end of your new cable ready to be pushed into it. Then just keep feeding until it's through. Pop a bit of grease on it too, doesn't hurt.</p></blockquote><p></p>
[QUOTE="Happystamps, post: 593095, member: 14679"] It shouldn't really be necessary. Pull the old cable out from the front and from the back if necessary, and try to push the new one in from the front. If it gets stuck at that bowden section, pull the guide tube out of the fan housing, and look over the gearbox for the flexi. You can pull that out of the steel conduit, where you'll find the end of your new cable ready to be pushed into it. Then just keep feeding until it's through. Pop a bit of grease on it too, doesn't hurt. [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Accelerator Cable Snapped - Best way to replace?
Top