Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
Anti roll bar bush
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="slow-lane-Matt" data-source="post: 626696" data-attributes="member: 19329"><p>To complete this thread my replacements from C&C were not split, and with a bit of washing up liquid were not too hard to force over the ends. I did take the roll bar of completely, would have been much more difficult to fit in situ.</p><p></p><p>The old bushes were branded VW, and were not split, and could probably have been re-used.</p><p></p><p>The replacement anti-roll bar bolts that came with the "bush kit" were too short - so keep the original nuts/bolts.</p><p></p><p>It was surprisingly easy to fit the retainer clip, using mole grips, tighten, release, tightened a bit further, then slid on and hammer the clip in place.</p><p></p><p>Easy DIY</p></blockquote><p></p>
[QUOTE="slow-lane-Matt, post: 626696, member: 19329"] To complete this thread my replacements from C&C were not split, and with a bit of washing up liquid were not too hard to force over the ends. I did take the roll bar of completely, would have been much more difficult to fit in situ. The old bushes were branded VW, and were not split, and could probably have been re-used. The replacement anti-roll bar bolts that came with the "bush kit" were too short - so keep the original nuts/bolts. It was surprisingly easy to fit the retainer clip, using mole grips, tighten, release, tightened a bit further, then slid on and hammer the clip in place. Easy DIY [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
Anti roll bar bush
Top