Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
EarlyBay Forums
Technical
anti roll bar kit fitting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Early Bay Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bac2ba6" data-source="post: 450469" data-attributes="member: 13538"><p>A combination of mole grips and a hammer usually works, 2 pairs of mole grips squeeze the edge together where the pin slides on and tap the pin over the 2 lips , slowly moveing the mole grips down, one at a time while taping the pin on a bit more , once you have got it on a good half way you can just tap it all the way home then with the mole grips off , it is a faff but usually works , the gsf ones are easier than the heavy duty JK ones believe it or not , lol</p></blockquote><p></p>
[QUOTE="bac2ba6, post: 450469, member: 13538"] A combination of mole grips and a hammer usually works, 2 pairs of mole grips squeeze the edge together where the pin slides on and tap the pin over the 2 lips , slowly moveing the mole grips down, one at a time while taping the pin on a bit more , once you have got it on a good half way you can just tap it all the way home then with the mole grips off , it is a faff but usually works , the gsf ones are easier than the heavy duty JK ones believe it or not , lol [/QUOTE]
Verification
Post reply
EarlyBay Forums
Technical
anti roll bar kit fitting
Top