EARLY BAY BEAM WITH RED9 COILOVERS - AXLE TO AXLE

[user 4039]

Im just about to make a final decision on whether to buy a Red9 front end for my bay. What Im looking for is to find out what I could get for my current solid - unwelded front beam with Red9 coil over 2-4" drop and red9 bumpstops. Replaced idler pin and bushes aprox 3000 miles ago. Bearings replaced as required throughout when needed for the MOT (all under 3000 miles). Complete with track rods etc. Aprox 3000 miles on the coil overs. Axle to Axle - no bearings/hubs/discs.

Too comply with rules Im asking £450.

Beam still fitted but am happy to remove it before the red 9 turns up. Its a 6-8 week wait for the red9 front end so if I strike a deal I would like a deposit of £50 to hold the beam for you til available. Im in Gloucester but could possibly deliver within say 50 miles for a fee.

 

[user 4039]

Bump

 

[GOM68]

Hi, so this is the complete EZ Rider kit, (trailing arm tie bars and coilovers) fitted in a beam?

What condition are the coilovers in, do they still adjust easily with the c spanner, no powder coating missing etc. You say they have only covered 3000 miles, however how old are they?

Thanks

GOM

 

[user 4039]

Yes it is the ez rider kit fitted to a beam. They have been fitted 3 years. I haven't tried to adjust anything since they were fitted but there is no signs of corrosion etc. I would have to check on the powder coating but as its peeing down that will have to wait. Have a look at this link. There are some photos but not a lot. http://s272.photobucket.com/albums/jj175/roxy270/" onclick="window.open(this.href);return false;

 

[Kustomlifespace]

You got PM !

 

[user 4039]

Replied

 

[user 4039]

SOLD