Mrs Chutney
Well-known member
This is the interior available free to collector, I'm based in Cwmcarn, Newport, S. Wales (NP11 7EU).
It was originally taken from my 1978 Bay, then used for a few years in my '71 Bay.
I believe its a Robert Holdsworth conversion, it comprises of 3/4 rear seat, Sink/Cooler Unit, Cooker Unit, Small Seat that sits behind drivers seat, a small unit that goes between the seats and Table. I searched and searched, but can't find a pic of the interior in the van.
We removed it to fit a full width R&R bed as we're both getting older and wider!
The front/top of the units has been covered in Fablon but can be easily removed and the glue cleaned off, probably with soap and water, or maybe acetate, its peeling off already so I don't imaging it to be a big job. (I decided to repurpose the Cooker unit, so had to strip the fablon and clean up before painting, this took all of 10 minutes).
The cooker is in full working order, has a wind break, and comes with the original grill pan, the Cooer unit has been re-used and is currently unavailable.
The bed is made up by unfolding the small seat, then the table fits in-between this and the rear sit, then the cushions fit in the space to make a mattress.
Unfortunately we had a leaky roof and the rear seat suffered some water damage, this isn't structural but would need cleaning, revarnishing or fixing.
This is ideally suited for someone who needs an interior on a tiny budget, personally I'd ditch the rear seat and replace it with a 3/4 Rock and Roll bed and you have a complete interior, I have an old set of R&R Brackets available also for a fair price.
The Table leg sits on the floor and then theres bracket to fit it above the middle/side storage box.
No cushions unfortunately as they have been reused elsewhere.
So altogether theres the bed that sits at the back to the right of the sink/cooler unit, and a buddy seat type box that sits behind the drivers seat, a table with leg and a bits that make up a small storage box between the rear seat and buddy seat. I will be replacing the Cooker unit shortly so that may be available later.
All available bits need to be collected asap otherwise they will be going to the tip as I need to free up the space.
Pics below
Bed
Water damage close up
Sink Unit
Cooler
Sink
Cooker Unit
Storage beneath cooker, box comes out to allow Gas bottle storage below.
Storage Box that sits between the seats
Side seat, unfolds to make bottom of bed
Table, shows the original colour under the Fablon. Also sits between rear seat and side seat to make bed
It was originally taken from my 1978 Bay, then used for a few years in my '71 Bay.
I believe its a Robert Holdsworth conversion, it comprises of 3/4 rear seat, Sink/Cooler Unit, Cooker Unit, Small Seat that sits behind drivers seat, a small unit that goes between the seats and Table. I searched and searched, but can't find a pic of the interior in the van.
We removed it to fit a full width R&R bed as we're both getting older and wider!
The front/top of the units has been covered in Fablon but can be easily removed and the glue cleaned off, probably with soap and water, or maybe acetate, its peeling off already so I don't imaging it to be a big job. (I decided to repurpose the Cooker unit, so had to strip the fablon and clean up before painting, this took all of 10 minutes).
The cooker is in full working order, has a wind break, and comes with the original grill pan, the Cooer unit has been re-used and is currently unavailable.
The bed is made up by unfolding the small seat, then the table fits in-between this and the rear sit, then the cushions fit in the space to make a mattress.
Unfortunately we had a leaky roof and the rear seat suffered some water damage, this isn't structural but would need cleaning, revarnishing or fixing.
This is ideally suited for someone who needs an interior on a tiny budget, personally I'd ditch the rear seat and replace it with a 3/4 Rock and Roll bed and you have a complete interior, I have an old set of R&R Brackets available also for a fair price.
The Table leg sits on the floor and then theres bracket to fit it above the middle/side storage box.
No cushions unfortunately as they have been reused elsewhere.
So altogether theres the bed that sits at the back to the right of the sink/cooler unit, and a buddy seat type box that sits behind the drivers seat, a table with leg and a bits that make up a small storage box between the rear seat and buddy seat. I will be replacing the Cooker unit shortly so that may be available later.
All available bits need to be collected asap otherwise they will be going to the tip as I need to free up the space.
Pics below
Bed
Water damage close up
Sink Unit
Cooler
Sink
Cooker Unit
Storage beneath cooker, box comes out to allow Gas bottle storage below.
Storage Box that sits between the seats
Side seat, unfolds to make bottom of bed
Table, shows the original colour under the Fablon. Also sits between rear seat and side seat to make bed
