Hi
I'm restoring a 1972 T2, it was a minibus with sliding doors on each side and a double front passenger seat.
Sadly it sat outside, not moving for the last 15 years.
Nearly ready for final body preparation before painting, last few rusty bits to cut out.
In each rear corner panel there is a round hole near the engine panel. Does anyone know what they are for? I would like to weld them up as they seem like an ideal place to let water in.
I'm going to try and attach a couple of pics.
Thanks for the great forum
Martin
I'm restoring a 1972 T2, it was a minibus with sliding doors on each side and a double front passenger seat.
Sadly it sat outside, not moving for the last 15 years.
Nearly ready for final body preparation before painting, last few rusty bits to cut out.
In each rear corner panel there is a round hole near the engine panel. Does anyone know what they are for? I would like to weld them up as they seem like an ideal place to let water in.
I'm going to try and attach a couple of pics.
Thanks for the great forum
Martin
