Recent content by aircoolsteve

Early Bay Forum

Help Support Early Bay Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    Pop Top hinge info needed please

    Hi all. Not been on here for a long while but I have a small problem with the fitting of some pop top springs to a roof cap. I've bagged a nice pair of springs but its obvious that they require a channel to run in to make them work with the roof. I have a pic of them and someone may recognise...
  2. A

    Headliner rods, track cover and repair panels

    have you still got this stuff? You mention an offside wheel tub? Is this for the front, and does it still have the seat runners on it? Thanks.
  3. A

    Need some seat fitting info please.

    Hi all. I have a 72 crossover bay and all the seat adjusters have been buzzed off. I want to reinstate original seats (walk-through). I've seen a lot of seats on the well known auction site and I'm looking at welding the runners back in after I buy them. The thing is, I don't have the info on...
  4. A

    WTD. Air filter shelf for 72 crossover bay

    Still looking!
  5. A

    WTD. Air filter shelf for 72 crossover bay

    Looking for the shelf that the oil bath air filter sits. Its often removed to fit twin carbs. Thanks.
  6. A

    Hesitation

    Try everything before you start on that inlet manifold!
  7. A

    Hesitation

    You really need to know that your carb is working properly before you get onto the icing issue. Take the carb off but don't pour the fuel out of it. hold it the right way up and work the throttle. Watch for the jet of fuel from the pump jet. If the jet is weak, that may be your problem. There is...
  8. A

    which bearing spins

    I've just completed a job on a split bus running a 2.0 type4 engine. It had a problem with the input shaft bearing which had disintegrated big time! The needles had come out and wrecked the friction plate and were laying on the bottom of the bellhousing. To get the input shaft some support on...
  9. A

    Hesitation

    Hard to guess without seeing it but it may be "icing" in the carb throat due to a blocked heat riser. It may not be getting enough fuel after the choke flap closes. Check out the float level in the carb and the float valve. Best to give that carb a service before you get onto the icing check as...
  10. A

    Garage clear out pre house move

    Pm'd ya
  11. A

    Garage clear out pre house move

    Post would be better. PM me details. Cheers
  12. A

    Garage clear out pre house move

    Could do with that walk through mat if you still have it
  13. A

    210mm clutch plate? WTD

    Hi all. I'm in need of a 210mm clutch or even just a friction plate for a type four flywheel (not car.....for bus) Cheers
  14. A

    FOR SALE: Roof rack

    i'll have it if you can get it to slough swap meet.
  15. A

    parts>>>>>>>

    i need the whole lot but have no pop top so don't want one with a big hole in it! and the bows of course. cheers
See more
Top