Help Support Early Bay Forum:
-
-
AAxlFoley replied to the thread Winter work thread.Have you got any photos of your setup? Where did uou get your handbrake cables?
-
AAxlFoley replied to the thread Winter work thread.I’ve got an old FutBus rear disk conversion that uses Golf calipers and I can confirm the handbrake is crap 😂 I think I could fettle it...
-
AAxlFoley replied to the thread My 69 Tin Top Westy.Well it seems the gearbox needs to come out for a rebuild, they hoped it would be a linkage issue but now think it’s an internal issue 🙈
-
AAxlFoley replied to the thread My 69 Tin Top Westy.Well it’s been dropped off and work has already begun, there is plenty of work ahead but it’s in the right place so it’s just a case of...
-
-
AIt's 10/24. The diameter of the screw is size 10 (3/16″) and it has 24 threads per inch
-
AStandard seat belt retaining bolts are 7/16 UNF, regardless of whether the vehicle has been manufactured with metric or imperial fasteners.
-
AJust buy a length of 3/16” UNC threaded rod and cut to the length you need. Any decent fastener supplier will have it, or eBay...
-
AAxlFoley replied to the thread My 69 Tin Top Westy.I thought I would post a long overdue update on my bay that I have owned coming up to 17 years, after many years of abuse and neglect...
-
-
AAxlFoley replied to the thread CB performance air filters.I feel you have both been there 😂 Thanks both will do.
-
ASorry, no I don't. But I can tell you it's definitely not metric. I'd be tempted to rethread the base and fit some M4/M5 threaded rod...
-
A^^^^^ this! it’s some god forsaken UNC thread, don’t know why the yanks can’t just use Metric like everyone else in the developed world...
-
AI have a set of these air filters but I’m missing two lengths of threaded bar to attach the top, I can’t figure out the thread type...
-
-
AIdel jet is the obvious place to start but even 6 month old modern fuel with ethanol will effect your running. I personally would not...
-
AThere are a couple of good YouTube videos on stripping down and rebuilding a 34 pict 3 which show the trick of how to remove the ball...
-
AAxlFoley replied to the thread Starter motor problems has anyone else have the same problem as me.I'll see if I can have a look, I've broken my leg at the moment so not totally mobile! it may take me a while.
-
-
Loading…
-
Loading…
