Recent content by gr00veg0d

Hi, can anyone recommend an engine builder in Cumbria or North of England?

Got a 1303s box hooked up to my 1776, and yep the higher cruising speed is worth it :)

Smallest commercial-rated tyres I could find were 185/60 R15C Continental VancoContact (load rated at 92/94)

this may help: http://forum.earlybay.com/viewtopic.php?f=4&t=53391

The centre caps will fit - you just have to trim down the retaining clips so they fit around the castellated nut...

WHS ^^^ I'm running 10" spacers with 195/75 tyres. It's a snug fit :msn4:

Here's my current setup Front: 185/60 R15C Continental VancoContact (load rated at 92/94) Transporterhaus 3.5" dropped spindles GAZ coilovers - (160/105/B12) with 140lb springs (RD1.9/140/10) - springs set at 9cm between bottom of adjuster ring and bottom weld mark with 10 clicks on the...

I put a washer under both of the mounting bolts to raise it slightly. Did the trick for me :)

Got mine here: http://www.alanhschofield.com/ourparts/prod_2850482-Steering-peg-211415223B.html

Might be more useful if I gave some details eh? I used to have about 4" of play in the wheel, after replacing the peg this is down to about 1.5"

Yes, and yes it make a BIG difference 8)

Just about to do this - any tips fellas?

So what happens if you don't have that rubber thing on?? Like I don't :(

Thanks dude that sounds just the job - I'll be ordering a pair in due course :D

So if I fit these dropped spindles with a stock width beam and lower profile tyres I should be able to avoid tyre rub? Sorry to be pedantic but I can't afford spindles and a new beam in one go!