matty74's latest activity
Help Support Early Bay Forum:
-
Todays progress…. Cargo floor bare metalled, what an unpleasant ordeal that was 💀😂 but it seems the red oxide I put down years ago... -
@matty74 That is a lovely finish on your interior!
-
Just buy a length of 3/16” UNC threaded rod and cut to the length you need. Any decent fastener supplier will have it, or eBay...
-
matty74 replied to the thread FBH fuel tank location….I put a flat tank behind the buddy seat / portaloo. The heater is under the van.
-
-
Mine's under the n/s seat, and the tank is in the engine bay with the pump mounted on the chassis leg.
-
i have a flat one off amazon behind the seat, the back of the seat hits the bulkhead before the seat back touches the the tank
-
Im cracking on with stuff atm, full service done, new seat belts, done, new windscreen wash switch and pipes - in progress. Also a...
-
I'll be taking our's into the factory i work, over the christmas shutdown so i can have plenty of room for: Long overdue gearshift...
-
I thought I would post a long overdue update on my bay that I have owned coming up to 17 years, after many years of abuse and neglect...
-
Another alteration/improvement I’ve been playing is this because since I’ve been using the nitrous in anger I’ve been suffering with...
-
We cc’d the combustion chambers on the new heads Saturday. They came in at 67cc, need them at 57cc to achieve a 10:1 compression ratio...
-
Hiya, don't use the filter you get with the kit, they fall apart easily, the green ,soft fuel line isn't brilliant either, get the hard...
-
I finally want to install my BA6 bellypan to protect my remote brake servo and prepare the bus for a big roadtrip next year.
-
2024 started off ok, did a couple of pub stopovers and Glampfest, then the year turned to ratshit. Threw the flywheel on the way to...
-
matty74 replied to the thread Crappy Year.Good to see you back 👍 but saddening to read what you’ve been through. Wishing you all the very best 👍
