Help Support Early Bay Forum:
-
-
You can drill a hole in the collar to access the grub screw , I’ll see if I can find the dimensions -
philstar replied to the thread sliding door handle help.@davidoft that would be great, if I can get a rough idea of the position of the grub screw underneath the collar I will try that!
-
philstar replied to the thread sliding door handle help.I am in a similar position, I bought a brand-new sliding door handle, which is locked, but don't have the key for it... What is my...
-
philstar replied to the thread Leaking front Windscreen seal..After much deliberation before fitting my new screen and seal a few months back, I used Arbomast Autograde Sealant for windscreens, the...
-
philstar replied to the thread Heater Tube Replacement.This is a great thread: https://earlybay.com/threads/heating-finally-sorted.79459/
-
Details here - https://www.eventbrite.com/e/midlands-air-cooled-swap-meet-2023-tickets-446640432557 And all over your socials, I...
-
philstar replied to the thread Initial engine break-in setup — running rough.I forgot to block the rear vacuum port on the carb which won't have helped things 🤦♂️ I have now re-assembled everything and got it...
-
philstar replied to the thread Stepped cam set up.I'm overriding the choke here by holding the whole spindle assembly fully open as far as it will go—the 'pin' that runs in the curved...
-
philstar reacted to Dirty Harry's post in the thread Initial engine break-in setup — running rough with
Like.
New engine has to brake in and compression increases as the bores get smoother en piston rings gave to bed in too. -
philstar replied to the thread Initial engine break-in setup — running rough.After a short delay fixing the T4 I have now performed a compression test on the engine, and it's not good reading. All cylinders are...
-
philstar replied to the thread Stepped cam set up.Trying to link my issue to a similar thread—when I hold the stepped cam fully open, the throttle screw doesn't correctly clear the final...
-
-
Loading…
-
Loading…