Recent content by squarebob

The date of your tent /awning may be stamped on the fabric just to the left of the entrance (from inside) near the floor. I couldn't find anything on mine, but I've learned many have a date stamp here.

Fantastic work yachty and cool Westy. Mycha directed me to your post in response to my question in the technical section about swapping the diagonal arms left-right for less camber on a lowered bus. I'm glad to see that you tried it -and it worked. Did it make a significant difference in...

Thanks Mycha, I'll check with yachty first and find out how much change to expect but it looks like it's worth trying. BTW I (finally) got the 2nd Camper Cookbook, nice to see your Westy in there! Bob

I am wondering if the diagonal arms can be swapped left-to-right to reduce the amount of rear wheel camber on a lowered bus as on an IRS beetle. Anyone try it? I couldn't find much info on this and looking at a a spare set of diagonals I have it looks easily doable with just the bump stop plate...

I like this panel, and the green vinyl looks awesome! -Nice work.

Some new additions... I needed a Porsche pattern spare that would fit right in the stock location. Since I couldn't find a lot of good info, here's what I did if someone wants to do the same. I bought a Porsche 944 spare from a guy in the local vw club, removed the collapsible tire and special...

Since no one has posted up Porsche teledials (or phone dials as they're called here in Canada) yet, here's my fave: I like Speedmasters for a wide-five wheel. 8)

Hey superfunkyfresh, I don't think the MA789's have the right mounting lugs to fit your bus. Check out the chart, it gives the lengths and a code for the upper and lower mounting configuration: (chart is from this link and the mounting codes are explained on page 5)...

As requested here are some pics of DOWN and UP with the air shocks but I couldn't fit the whole bus in the shot with my camera in the garage. Front at 10psi: And at 120psi: Back at 10psi: And at 120psi: ...can't see the difference? -Look closer, it's only about 4cm! The adjusters are set...

^^Awesomeness!^^

The previous owner of my bus is a friend and I know he painfully tried a couple of different adapters before he found the right (these) ones. I'll contact him to see if he has anymore info or specific H&R part number. If I find out anything more, I'll post it up here.

Hey Gary, nice Westy! -I like Sierra Yellow. My adapters came with the bus so I can't say specifically which retailer they came from. They are H&R which are available through various suppliers, you'll have to search around. Search: H&R wheel spacers (or adapters) 5x112 to 5x130. I know they...

I just double checked adapters and they are 25mm. Here's a pic of the adapter on the scratched-up drum and also a pic of the wheel installed and with the bus in the low-down position from my thread.

Mycha, it’s been a year already (slowest project ever) since I figured out the lengths I needed using this chart: I don’t remember anymore what my compressed length needed to be for the front, but I must have thought the MA824’s compressed length (12.75 inches) was too long with my setup and...

I'm in project phase so my sink is still holding small parts. A friend though, told me he fills his with ice and has a small 12v fan that blows over it to keep his wife cool during hot summer drives and reports that it's actually quite effective!