Search results

I git hold of a Subaru ej20 engine and loom set of a supposed specialist breaker The engine is fine but he sent a me a loom that didn’t match the Ecu he sent and wrong for the engine so I’ve got a loom on order of Nick which should be her soon I’ve spruced the engine up and got an RJES...

I have started priming and sealing some area now as I go along and have fitted drivers side door skin and finished the centre section and rear quarter panel

Hi guys I haven’t been on here for quite a while I have been only pottering around on the bus due to very busy home life, my partners mother moved in with us two years ago with dementia and Parkinson’s and has needed round the clock care which I have helped with, anyway things have eased a bit...

Hi thanks for that but I have the engine already sorted just after bellhousing to fit to bus box if not I will speak to RJES

Hi I’m looking for any Subaru conversion parts preferably a bellhousing if possible Many thanks

Hi does anyone know the upto date discount code for Schofield's I have tried various earlybay configuration but none work Thanks

Cheers guys I have been reading through your thread bluesman it's very i.impressive you have done a good job there Thanks for the pic advice up look into opening an account with image host to try and sort the pics out

Some of these are in the wrong order lol I’m sure you can figure it out How do get pictures to show larger I have tried re sizing but it Dosent seem to change anything

I have nearly finished the chassis repairs on the drivers side now as well just need to fabricate the rear bump stop thing and weld it on This was the last of the holes

I have replaced the jacking points at the front Just need to fit the rear then can look at repairing the floor pans and re fitting them I have repaired the I beams and replaced the front cross member half section till I get the other side

Hi everyone not posted for a while but have been busily working away in the van when I can I took the newish inner sill off that PO had installed by said restored who fitted it in the completely wrong place I have now re fitted it and fitted the inner sill strengthened as well I have...

The photo above is the inner rear chassis repair I still have to repair front and rear cross members but want to put some new metal back in first before I cut them out This is the position now it’s a bit messy at the minute but I am in a single garage so pushed for room

Took the floor out to get to the top hats properly And also found the PO had fitted the inner sill completely wrong as in too low and welded to the B post in the wrong place So took it off so I can relocate it when I put the jacking points in after the front chassis leg repairs

Not had a lot of spare time recently but managed to get a few days on the van I want to get the O/ S sill on so can get the rear arch in and welded but have to replace all the out riggers and repair/ replace I beam and top hats where needs Had to repair a big hole and years of crappy MOT...

Still all needs a good clean up and I will probably shot blast the worst of the inner comer Can’t seem to find anyone who makes D posts so I think I’m going to try and modify some box section and a length of u channel maybe

I’ve been carefully cutting away the rot and managed to rebuild a section of it to get the hinge in the right place and the tailgate opening and closing I still need cut the centre of the rear gutter/roof out so I can finish the repairs and fir the new tailgate upper panel

Hi guys I’ve been furloughed again so I’ve managed a good day in the camper today Mainly the rear roof and N/S hinge area was rotted out completely The D post is completely knackered too and the corner has already been worked on with someone with sunglasses on I think

Hi Chad I have sent you a pm but not sure if it’s gone through I’m interested in the engine kids where about a are you in Norfolk Mick

Hi I’m on the lookout for various panels for my 1968 bus I’m based in north Norfolk but willing to travel for some parts or happily pay postage/courier fees I need a Engine lid Rear valance Front doors Need a gearbox too but not too rushed with that yet unless something turns up Many thanks