WHAT PANELS

[busdiver]

hi all, new on here, but been on VT for a while but a mate suggested here as better for me on early bay stuff, we've had our crossover for 5 or 6 years now and the time has come for a face-lift and some structural chassis work.

who do you suggest as the better producer of panels, i am gonna need

both complete front arches
cab floor panels
inner and outer bottom repair on front bumper area
and the chassis member under the drivers floor (the short bit that goes onto the main chassis)

thats just for starters on the front :shock:

can you get a complete chassis leg bit or do you have to use the wrap around repair in two peices.

and does the inner and outer sections meet the step front edge or is there more bits to complete that section.

will start a thread shortly got my 1st pics of her in the lockup.

your advice would be appreciated. oh yeah hoping to order bits in for the weekend...................... :lol:

thanks Aj.

 

[Marvel]

If you can, try and source panels/parts cut from a bus, that way you'll know they'll fit. FBI is a good start

 

[G11NNR]

I got all my panels from justkampers, they were ok but nearly all needed modifying in one way or another to fit properly. I got the later front arches and cut the steps out but I think they are doing proper ones now but cost a lot more. I put new jacking points om mine and they fitted ok, inner, outer and middle sills on both sides and they were ok, front panels had to be cut and welded together and the bit I think you are on about the inner and outer front valance I bought as a complete section and it also fitted ok, the main problems were the panels just not being the same as the originals.