Help Support Early Bay Forum:
-
-
matty74 reacted to andrewblackwell's post in the thread Front badge hole location, measurements? with
Like.
I finally got our NOS nose badge fitted, with measurement help from @mike202 I drew a template on CAD, covered it in clear tape to make... -
Cheap Amazon Bluetooth radio, the volume control was a bit flaky after 3 months and they sent a new one, in the meantime I started using...
-
Or a Maypole cover 👍
-
Having an issue with uploading photos for some reason but hopefully these work…. The other show I went to last year, other than my own...
-
Progress 🤓
-
Nice dry sunny day here yesterday so took Bus out for its first drive with rebuilt engine. 10 miles trouble free. Tickover was a bit...
-
Just bought a seriously decent set of jump leads from Lidl for twelve quid. The reason these would be absolutely fabulous for an Early...
-
They fit, just….. cig paper clearance 🤓 really want to keep the 215/60 15 but I’ll go to a 205/65 15 if they touch at all. Hopefully the...
-
The next job is to refit the 44's and sort out the throttle linkage. For some reason on this engine case I can't get full throttle...
-
Sliding door card, part 57. After breaking yet more of these damn clips, I've finally managed to get them all lined up and ready to fit...
-
Awesome looks good mate 👌🏻
-
matty74 replied to the thread Winnie - Our 1970 Bay.Treated Winnie to a new Pierburg Fuel pump, the old one was looking past its best. Fuel delivery into regulator looks a lot more...
-
-
Went and saw Pete at cogbox last week who milled 5mm off the back of my fondmetals Got a sensible amount of clearance now 😄 Excuse...
-
Remember that a van is like Trigger's broom, just because the one you took off is such and such doesn't mean it is correct..... go for...
-
-
Loading…
-
Loading…
